After deploying a single FTD at the remote site my next task was to configure two FTDs in a redundant High-Availability (HA) setup with Active/Passive fail-over. Again, I had to make sure the following requirements are met. configure FTD at the staging site with limited onsite availability ssh remote-access …
Tag: VPN
I was looking for ways to setup FTD for remote site deployment and after some time of gathering different information from other sources(1,2,3), I thought of writing this post to show what worked best for me in this setup. If remote site has a single Internet connection deploying ASA …
Came across this task to set up a posture assessment for workstation domain membership check when connecting with Anyconnect (AC) VPN to Cisco ASA and enforce access based on compliance. ISE was already deployed for simple VPN authentication so, first of all, I had to make a decision on what …
I was setting up a site to site VPN over MPLS link and ran into this error message: Inbound TCP connection denied from … to … flags SYN on interface… This error would generate when traffic was entering Hub ASA and was suppose to traverse VPN tunnel and reach the …
This issue had me going for a bit because it started happening on a working production unit after public IP address changed. After updating all the proper VPN setting with new IP address a working tunnel would not establish for some unknown reason. Initiating side would display a message stating …